I am well familiar with MathCad numerical calculations and programming. However, I got accustumed to work my solutions without alphanumerical dimensions next to the number or variable. It is clean an easier for me to keep track of units and conversion in my mind than assigning units to numbers and varaibles at the beguining of calculations or programming with MathCad.
I tried otherwise recently but with problems. My question is to anybody: What is the best way not to get bugdown with error messages becuase units have not been defined properly at the beguining of any problem set-up or during calculations?
I am a structural enginer and work often with Kips, U.S. Tons, Yards, ft., inch.,etc. How do you mix these units in calculation and get the correct answer without keeping track of their different units? Help is appreciated. Thanks.
I tried otherwise recently but with problems. My question is to anybody: What is the best way not to get bugdown with error messages becuase units have not been defined properly at the beguining of any problem set-up or during calculations?
I am a structural enginer and work often with Kips, U.S. Tons, Yards, ft., inch.,etc. How do you mix these units in calculation and get the correct answer without keeping track of their different units? Help is appreciated. Thanks.